Concrete repair and leveling in Palm Bay: lift it, fix it, and fix what sank it
A driveway apron that dropped at the swale, a pool deck that settled where the pool was backfilled, a walk with a trip lip, a slab with a crack you can put a coin in. We lift sound slabs with polyurethane foam, replace the sections that are past it, and fix the water problem that did the damage.
Concrete in Palm Bay fails from underneath. Sand washes out from under an apron because the culvert is silted; a pool deck settles because the backfill around the shell was never compacted; a garage-side slab drops because a downspout has been dumping at its corner for twenty years; a walkway heaves because a laurel oak's roots got under it. The slab itself is usually fine — it's just in the wrong place. For those we use polyurethane foam lifting: dime-sized holes drilled through the slab, a two-part foam injected under it that expands and lifts the slab back to grade in minutes, holes patched, and you drive on it that afternoon. It's a fraction of the cost of replacement, and it leaves the slab you have.
What foam can't fix, we replace: sections that are broken into pieces, slabs that are too thin or unreinforced to lift, aprons that are cracked across the culvert, decks that have separated from the coping. We cut the bad section out on a clean saw line, rebuild the base, dowel into the good concrete and pour to match. Cracks that are stable get routed and sealed; spalls get a bonded patch; a pitted or scaled surface that's sound underneath gets a resurfacing overlay. And every repair comes with the reason it happened: we flush or replace the culvert, extend the downspout, regrade the swale, cut the root — because lifting a slab and leaving the water where it was just means we'll see you again in three years.
What's included
Polyurethane foam lifting
Sound slabs lifted back to grade through small holes in minutes; driveways, aprons, decks, walks, garage and lanai slabs.
Section replacement
Broken sections cut out on a saw line, base rebuilt, doweled into the good slab, poured and finished to match.
Crack and spall repair
Stable cracks routed and sealed; spalls and pitted areas patched with a bonded repair mortar.
The cause fixed
Culvert flushed or replaced, downspouts extended, swale regraded, roots cut or bridged — part of every repair quote.
Coping joints and deck drains
Open coping joints resealed and deck drains reset so a lifted pool deck stays lifted.
Honest triage
If it's cheaper to replace than to lift, or if it's fine as it is, we say so.
Concrete repair and leveling cost in Palm Bay, FL
| Job | Typical price | Notes |
|---|---|---|
| Foam-lift a sunken driveway apron | $800 – $2,000 | Plus culvert clean-out if needed |
| Foam-lift a settled pool deck section | $900 – $2,600 | Coping joint reseal recommended |
| Foam-lift a walkway, stoop or lanai slab | $500 – $1,500 | Same day |
| Cut out and replace a driveway section (100 sq ft) | $1,100 – $2,000 | Doweled, matched |
| Crack routing and sealing (per lin ft) | $8 – $18 | Stable cracks |
| Spall or pit patching (per sq ft) | $12 – $28 | Bonded mortar |
These are 2026 Brevard County ranges so you can budget. Your written price is itemized — demolition and haul-off, base, thickness and steel, finish, joints, sealing, permit — and good for 30 days.
Recent work



Questions we get about repair & leveling
Foam lifting or mudjacking?
Foam. Mudjacking pumps a heavy cement slurry through two-inch holes, adds weight to sand that's already failing, and washes out again the next time the water comes through. Polyurethane foam is light, goes through much smaller holes, doesn't wash out, and cures in fifteen minutes. Nobody in Brevard should be mudjacking anymore.
Will a lifted slab sink again?
Not if the water problem is fixed. The foam itself doesn't compress or wash out; what sinks a slab a second time is the same culvert, downspout or swale that sank it the first time. That's why every lift we do comes with the drainage fix quoted alongside it, and why we won't lift an apron over a crushed culvert without replacing the pipe.
Can you lift a slab that's cracked?
If it's cracked into two or three big pieces that are otherwise sound, yes — we lift the pieces to a common grade and seal the crack. If it's cracked into a puzzle, or it's the old two-inch unreinforced pour from a 1970s GDC lot, it'll break more when it moves, and replacement is the honest answer.
How fast can you come out?
A slab that dropped under a car or a deck that's pulling the cage posts gets a same-day look when we can; most repair estimates are within two days and most lifts are done within the week.